How to Professionally Remove Carpet Stains
2 min read
5 Steps to Remove Common Spots and Stains
Cleaning carpets is a process most cleaning operatives will have to face at some point in their careers. We've created a guide on how best to remove stains, whether they're old, new, on synthetic or wool carpets.
1. Remove any solids by gently scraping with a blunt knife or spoon.
2. Remove any liquid by blotting with a clean, absorbent cloth or paper towel.
3. Apply Jangro Spot & Stain Remover to the area and leave for 5 minutes.
4. Blot the treated area with a clean, absorbent cloth or paper towel to remove the loosened stain and excess solution.
5. Repeat the application until the stain is removed. Allow the carpet to dry thoroughly between applications to avoid over-wetting.
Removing More Problematic Carpet Stains
If it's more stubborn carpet stain removal advice you're looking for, the following tips should help you overcome some of the challenges you may encounter.
Burns
If the carpet is wool, the damage will probably be restricted to surface charring. A gentle rub with fine-grade sandpaper will remove the mark.
If the carpet is synthetic, the fibres may have melted together into a hard black lump, which you may be able to cut out. Unfortunately, the area you remove may remain visible unless it is covered or repaired.
Candle Wax
Place a clean white absorbent cloth over the affected area and lightly apply heat with a warm iron. Do not place the iron directly onto the carpet. Absorb as much wax as possible into the cloth, then use Jangro Carpet Spot & Stain Remover.
Chewing Gum
Freeze the gum using a chewing gum freezer spray. Remove the hardened gum, then treat the remaining stain with a suitable stain remover.
Indentations
Indentations caused by furniture or other heavy objects can often be reduced by placing an ice cube on the affected area and then gently brushing the fibres once dry. We've also found that using steam carefully can help lift the carpet pile.
Nail Varnish or Glue
Dampen a white cloth with nail varnish remover or paint thinners, then gently apply it to the affected area. Take care due to the flammability of the solvents. We recommend testing first in an inconspicuous area to ensure no damage occurs to the carpet fibres.
Oil-Based Paint
Blot excess liquid with a soft, absorbent cloth or paper towel, then dampen a cloth with a small amount of turpentine. Carefully dab the affected area before using a solvent-based stain remover.
Rust
Use a specialist rust remover or apply a 1% solution of oxalic acid* (available from chemists) in warm water to the affected area. Allow it to stand for up to 15 minutes before blotting. Repeat as necessary, then finish with a stain remover.
*Use with caution, as oxalic acid is poisonous.
Additional Wray Bros Top Tips
- Avoid rubbing excessively, as this can permanently distort the carpet fibres.
- If a stain is old, apply a cleaner and allow it to dwell for longer before removing it.
- Avoid over-wetting the carpet.
- Always take extra care when using flammable solvents.
